For daily use
Switching on and off
>
Switch on the digital receiver bypressing the
On/Standby
key, either on the receiver or on the
remote control.
>
Press this key again to switch the receiver off.
>
The receiver is now in standby mode, the display on
the receiver shows the time.
Programme selection
Using the programme up/down keys
>
Use the
programme keys up/down
either on the
remote control or on the receiver to move up or down
one programme slot at a time.
Using the numeric keys
>
Use the numeric keys to enter the desired programme
number.
For example
1
for programme slot
1
1
, then
4
for programme slot
14
2
, then
3
, then
4
for programme slot
234
When entering programme numbers consisting of several
digits, you have approximately 3 seconds after pressing a key
to complete the entry.
If you wish to enter a number consisting of only one or two
digits, you can speed up the switching procedure by keeping
the key depressed a little longer on the last digit.
Using the programme list:
>
Press
OK
.
>
You can now use the
arrow keys up/down
to mark
the desired programme.
>
Press
OK
to switch to the marked programme.
>
Use the
arrow keys up/down
to move the marker
by one line at a time within the list.
>
Use the
arrow keys right/left
to move the
marker around the list one page at a time.
Volume control
>
You can regulate the volume of your digital receiver:
press the key
to increase the volume, and
Volume -
to decrease it.
>
Press the key
Sound on/off
to switch the sound on
or off (mute).
54
2233450003900
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 54
