CONTROL UNIT
The Evolution Control Unit can be mounted inside or outside of the growing area.
Mains voltages are present in the control unit and water must not under any
circumstance be allowed to come into contact with the unit. Wall mounting is preferable
using the mounting slots at the back of the unit.
The unit should always be plugged in via an approved RCD breaker.
SENSOR PROBE
The Evolution sensor probe should be suspended from a suitable hanging point,
preferably around level with the plant tops in your growing area.
The sensor probe is a sensitive piece of equipment and should be handled with care.
Under no circumstance should the sensor probe be submersed in water.
PRE-INSTALLATION
Careful consideration at this stage can save a lot of time and trouble later on!
Common considerations would include Power Source, Cable Lengths, Sensor
Positioning, Control-Unit Positioning, Water Sprayers / Spillages etc.
2
Controller Installation
Example system setup
