Technicolor COM1000, Integrator'S Manual

Page: 61 / 129

61
Following is a detailed list of the information available on the HealthInfo page.
Chassis – This field reports a unique identifier for the chassis. In systems that contain multiple
chassis, this can be used to identify each card in the system. See Section 4.1 on how to assign
unique identifiers to multiple chassis within a system.
Slot – This field identifies the card‟s location within a chassis, numbered 1 through 12.
CardIP – This field shows the IP address of the COM24 card that resides in the chassis and slot
combination to its left.
Card_Temperature – This field reports the temperature of the COM24 card, as measured on its
surface. This essentially gives the ambient temperature inside the COM200 chassis.
IC_Temperature – This field reports the internal temperature of the main processor chip on the
COM24 card. An elevated temperature here and nowhere else could mean that this chip is
defective.
PS0 Health – This field reports the health for Power Supply 0. If the power supply is connected
and operating properly, the value should return “OK”. If there is a problem with either of these
things, the value will return “Fault”.
Note: Newer chassis will only have a single power supply instead of a dual power supply. These
power supplies do not provide health indicators so the PS0 and PS1 Health indicators will report
Fault, which should be ignored.
*See device labeled “AC Input 1” in Figure 3 in Section 3.2 .
PS1 Health – This field reports the health for Power Supply 1. If the power supply is connected
and operating properly, the value should return “OK”. If there is a problem with either of these
things, the value will return “Fault”.
*See device labeled “AC Input 2” in Figure 3 in Section 3.2 .
Fan0 Health – This field reports the health for Fan 0. If the fan is connected and operating
properly, the value should return “OK”. If there is a problem with either of these things, the
value will return “Fault”.
*See device labeled “Exhaust Fan 1” in Figure 3 in Section 3.2 .
Fan1 Health – This field reports the health for Fan 1. If the fan is connected and operating
properly, the value should return “OK”. If there is a problem with either of these things, the
value will return “Fault”.