82
Fig. 10-18
Recheck the items to check before the test run.
Set the outdoor unit system address.
Set the remote controller to “test run.”
Turn ON the indoor
and outdoor power.
Return the remote controller to normal
control.
YES
YES
YES
NO
NO
NO
(See 10-22-3, 4)
( * )
(See 10-20)
(See 10-21)
(See 10-19)
(See 10-22-1)
Check the combination (wiring) of indoor and
outdoor units.
Is system “single-type”?
Is outdoor unit multiple?
(See 10-22-2) How to Set the Outdoor Unit System Address
Set the automatic address setting from
outside unit or remote controller.
(See 10-22-1) How to Set Automatic Address
Can
operation be
started?
Refer to “Table of Self-Diagnostic
Functions” to check the system.
In addition, refer to Item 10-22 and
correct any items that need to be
corrected.
Note: Check the indoor-side drainage.
(*)
Required for simultaneous-operation
multi systems and for group control.
Automatic Address
Automatic Address
Indicate (mark) the combination number.
Turn ON the indoor and outdoor power.
10-18. Test Run Procedure
04-393 DC INV Tech p 64-110 12/13/04 11:35 AM Page 82
