100
CAFP
11-2. Accessories
11-3. Wiring the Receiver Unit
●
Connect the wire from the receiver unit to the
indoor unit remote controller terminal board. (The
wire has no polarity.)
11-4. Precautions on Simultaneous Installation of
Wired Remote Controller and Wireless
Remote Controller
By installing a wired remote controller, the wireless
remote controller kit can permit dual remote control
operation at the same time.
(Up to 2 units of remote controllers – a wireless kit
and a wired unit – can be installed.)
Dual remote control operation can control 1 or multi-
ple air conditioners using several remote controllers.
1
1
2
1
3
1
4
6
7
5
Fastening screw
4
×
12
Remote
control unit
Remote
control holder
Parts
Q'ty
Parts
Q'ty
AAA alkaline
battery
Receiver
unit
Tapping screw
4
×
16
Clamp
No.
No.
2
2
1
1
2PWHT
CN001
WHT
BLK
Indoor unit
Receiver PCB
Remote controller
Terminal board
CAUTION
●
Be sure to determine the correct ter-
minal numbers on the indoor unit
when wiring the remote controller.
The remote controller will be dam-
aged if high voltage (such as 220 –
240 VAC) is applied.
●
The wireless remote controller kit
components cannot be used for
more than 1 indoor unit at a time.
(However, separate receiver units
may be used simultaneously.)
●
When a wireless remote controller
kit and a wired remote controller are
used simultaneously, assign either
the wireless remote controller or the
wired remote controller as the sub
remote controller unit.
●
Connection diagram
04-393 DC INV Tech p 64-110 12/13/04 11:35 AM Page 100
