MAFP
25
Fig. 3-19
3-8. Installing the Rear Panel onto the Wall
Confirm that the wall is strong enough to support the unit.
See either Item a) or b) below depending on the wall
type.
a) If the Wall is Wooden
(1) Attach the rear panel to the wall with the 10 screws
provided. (Fig. 3-19)
If you are not able to line up the holes in the rear
panel with the beam locations marked on the wall, use
Rawl plugs or toggle bolts to go through the holes on
the panel or drill 5 mm dia. holes in the panel over the
stud locations and then mount the rear panel.
(2) Check with a tape measure or carpenter’s level.
This is important so that the unit is correctly
installed. (Fig. 3-20)
(3) Make sure the panel is flush against the wall. Any
space between the wall and unit will cause noise
and vibration.
b) If the Wall is Brick, Concrete or Similar
Drill 4.8 mm dia. holes in the wall. Insert Rawl plugs for
appropriate mounting screws. (Fig. 3-21)
3-9. Removing the Grille to Install the Indoor Unit
In principle, with this model wiring can be completed
without removing the grille.
However, if it is necessary to change the settings on the
PCB, follow the procedure below.
Removing the grille
(1) Lift up on both sides of the air-intake grille to open it.
(Fig. 3-22)
(2) Remove the filter. (Fig. 3-22)
(3) Adjust the flap so that it is horizontal. (Fig. 3-23)
(4) Open the installation screw covers below the grille
(3 locations). (Fig. 3-23)
(5) Remove the screws. (Fig. 3-23)
(6) Remove the grille. (Fig. 3-24)
Attaching the grille
(1) Close the flap.
(2) Keep the grille installation tabs aligned with the top
portion of the grille, and reinstall the lower portion of
the grille.
Fit the installation tabs into the grooves and press
the lower portion of the grille back into its original
position to install it.
(3) Press on the installation tabs to completely close
the grille.
Check that the grille and frame are fitted tightly
together.
Fig. 3-20
Fig. 3-21
Fig. 3-22
Fig. 3-23
Fig. 3-24
4.8 mm
dia. hole
Rawl plug
Intake grille
Filter
Flap
Open the grille
Installation screw cover
Remove the grille
04-393 DC INV Tech p a-44 12/15/04 3:04 PM Page 25
