3
NAME OF PARTS AND OPERATION SELECTOR SWITCH
EG
NOTES
●
It is possible to set the air conditioner in order to let
the OPERATION, TIMER and STANDBY lamps always
OFF, even during operation.
Press contemporary the IFEEL and FAN buttons on
the remote control unit for more then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
●
In case of troubleshooting the air conditioner
diagnostic system activates the lamps accordingly,
even if they are set to OFF. See paragraph
TROUBLESHOOTING for further details.
6
2
1. Remote control unit.
2. Remote control sensor: Detects the room temperature
around the remote control unit, the air conditioner is
controlled accordingly.
3. Air outlet: Conditioned air is blown out of the air
conditioner through the air outlet.
4. Air intake: Air from the room is drawn into this section
and passes through air filter which removes dust.
5. Remote control receiver: This section picks up infrared
signals from the remote control unit (Transmitter).
6. Operation selector (without remote control): Push
the button to walk through the operation modes (OFF,
COOL and HEAT)
7. OPERATION lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored.
8. STANDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
9. TIMER lamp: This lamp lights up when the system is
being controlled by the timer.
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
WARNING
7 8
9
5
3
4
2
1
6
1
MULTI SPLIT
●
The blinking of TIMER and STANDBY lamps and
OPERATION lamp ON, indicates that the operating
mode selected is not compatible with the unit. If this
happen the air conditioner does not operate until the
correct mode is selected.
●
AUTOMATIC Mode is not available.
If this mode is selected OPERATION lamp is on,
STANDBY and TIMER lamps are blinking.
only
3
9
9
7
7
8
5
4
