TECHFASS 534821E2, Manual

Page: 22 / 26

www.techfass.com RFID reader module MREM 82 NOGBKP, NIGBKP 22
7.10.1 Inserting cards (ID codes) into the memory
Follow these steps for inserting cards into the reader module’s memory:
Step 1 Step 2 Step 3
Read the programming card
for
inserting : the reader goes
into programming mode .
One by one, read the cards
which are to be granted
access. About 15 seconds after
inserting the last card the
reader module goes back
into
standard operating
mode .
Inserting cards
7.10.2
Deleting cards from the reader’s memory
For deleting the cards from the reader module’s memory use following steps:
Step 1 Step 2 Step 3
Read the programming card
for
deleting : the reader goes
into programming mode .
One by one, read the cards
which are to have their
access revoked. About 15 seconds after
deleting the last card the
reader module goes back
into
standard operating
mode .
Deleting cards
7.10.3
Deleting cards „above or below“
If a user loses his ID medium, it is usually impossible to delete the ID from the memory with the procedure described in
the previous chapter, since the medium is no longer available (with an exception of entering the code at the keypad).
Following procedure can be used for deleting such ID. The procedure
requires using an ID medium , which was inserted
right before or right after the ID medium , which should be deleted.
Step 1 Step 2 Step 3
Read the programming card for
inserting : the reader goes into
programming mode , which is
indicated by slow flashing of
yellow LED.
Read the programming card for
inserting 5 times in a row; the
reader will go into
Deleting
cards “above or below”
mode
indicated by fast flashing of
yellow LED.
Read a card, which is located
in the module’s memory
right
before or right after the card
you wish to delete. After this
step the module quickly flashes
with yellow LED
Step 4 - A Step 4 - B Step 5