33
PV PRESET TEMPERATURE
This parameter enables the hot water temperature to be set. This is done during a single (at least) 5-minute long signal sent
through the PV inverter contact point. It is binding for at least 30 min.
NOTE
The PV preset temperature is superior to the standard preset temperature.
ANTI-FREEZING
The user selects the heat source (heater or heat pump) during the activated anti-freezing process.
WEEKLY SCHEDULE
This function can be used to program the activity of the heat pump in its daily operation cycle for particular weekdays down to
one hour.
1.
After pressing the weekly regulator edit icon, the weekday selection screen appears. This is what you use to select the
settings you want. Using the arrows, you can change the weekday. When the day you want to change the settings for is
selected, click its icon.
2.
The settings change screen then appears on the controller's display. You can now select the hours when the heat pump
is to be active.
The following hours are selected on the below screenshot:
10
00
- 21
00
–
this means that the heat pump is to be active in those hours, while in the other ones it will be switched off.
3.
Then, the possibility to copy the settings to the other weekdays is displayed:
Summary of Contents for ST-53.4
