Tecfrigo SOMMELIER, Installation, Use And Maintenance Manual

Page: 13 / 40

•
Ambient temperature below 0°C or above 38°C will hinder the performance of the appliance.
•
This unit is not designed for use in a garage or any other outside installation.
•
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
•
The device requires an adequate flow of air in order to operate correctly. Leave a clearance of
8 cm around the appliance.
•
Do not cover up any openings on the device and do not block these off.
•
The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
•
For energy saving reasons please ensure that the door is closed when the appliance is turned
on.
There are FOOT (3 bigger feet and 1 small foot). To level your appliance, adjust the front legs
at the bottom of the appliance.
The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of the
wine shelves can be removed to accommodate larger bottles. Maintain a minimum 20mm
between bottle and back plate.
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
Please note
►
Ensure that the tabs are firmly engaged in place before storing any bottles.
►
Any of the wine shelves can be removed to accommodate larger bottles.
►
Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the cabinet.
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a crosssection of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under or over hot or
sharp surfaces.
•
This unit is not designed to be installed in an RV or used with an inverter.
•
The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a
protective conductor are prohibited.
Legs/feet
The handle installing (FIG.1)
Wine shelves (FIG.2)
To remove a shelf
Electrical connection
13
rigo
Italiano
EnglishFrançaisDeutsch