Tecfrigo SOMMELIER, Installation, Use And Maintenance Manual

Page: 12 / 40

Tecf
12
Italiano
EnglishFrançaisDeutsch
►
Do not operate this device if its power cable or plug is damaged, if it does not work properly
or if it is damaged or has been dropped. If the power cable is damaged, it will need to be
replaced by the manufacturer or his service agency or a similar qualified person, to avoid any
dangers.
►
Do not open the housing on the device under any circumstances. There is a danger of an
electrical shock if live connections are touched and the electrical or mechanical structure is
altered. In addition, functional faults on the device can also occur.
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
►
Packaging materials may not be used for playing. There is a danger of suffocation.
►
Transport, unpack and use two persons to set down the device because of the heavy weight
of the device.
►
Examine the shipment for its completeness and for any visible damages.
►
Immediately notify the carrier, the insurance and the supplier about any incomplete shipment
or damages as a result of inadequate packaging or due to transportation.
To unpack the device, proceed as follows:
•
Remove the device out of the carton and remove the packaging material.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Your wine refrigerator should only be moved in an upright position.
•
After at least 10 minutes, plugging the appliance into the wall outlet, than place wine bottles or
beverages in the appliance.
►
Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required to
“
Green Dot
”
recycling collection points for disposal.
►
If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
•
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption.
Safety information
Please note
Unpacking
Please note
Disposal of the packaging
Please note
Setup
Setup location requirements: