3. DISASSEMBLY
AND
REASSEMBLY
EO18-13004
3.3 Disassembling the Mechanism Unit
3- 8
Removing the Center Frame
1. Remove the PNE lever ass’y, sensor plate, guide roller and DIP switch cover with the slider.
2. Remove the BT-2.6x6 screw to detach the sensor PCB ass’y.
3. Remove the slider from the DIP switch cover.
NOTE: When reassembling the sensor PCB ass’y, hook its one end and then install it with the
screw.
3.3.4 Removing the Gears
1. Remove the two ST-3x6 screws to detach the gear holder.
2. Remove the reduction gear and then idle gear from the gear holder.
NOTE: Apply lubricant (Molykote EM-10L) to the shafts of the gear holder (shaded portions) when
replacing the reduction gear, idle gear, or gear holder.
Slider
DIP Switch Cover
Guide Roller
BT-2.6x6
Sensor PCB Ass’y
Sensor Plate
PNE Lever Ass’y
Center Frame
Fig. 3-14
Main Chassis
Reduction Gear
Gear Holder
Idle Gear
ST-3x6
Fig. 3-15
