TEC MA-1595-1 SERIES, Owner'S Manual

Page: 128 / 218

6. PROGRAMMING OPERATIONS
EO1-11152
6.5 Cashier Code and Name Programming (Submode 2)
6-11
6.5 Cashier Code and Name Programming (Submode 2)
Cashier Code and Name, and Cashier Status for each cashier can be programmed here.
6.5.1 Programming
Any time outside a sale
Mode
Lock: SET
2
[X] |Cashier Code| [NS]
1
[ST] Character entries [ST]
2
[ST] |Cashier Status| [#]
[AT/TL]
NOTES:
1. The following table shows the Cashier Codes that can be entered (the capacity is determined by
the RAM Allocation Setting).
Standard memory Expansion memory
Code entry type 1 to 15 1 to 99
Cashier key type [CLK] key 1 to 8, 99* ---
* The Cashier Code 99 for the Cashier Key Type is fixed as a code of a cashier for Training
Entries.
2. For the name of each cashier, a maximum of 12 regular-sized or 6 double-sized characters can
be entered. A combination of both types is also available.
3. Training entry status is available for every cashier.
4. When the center file is used, this programming cannot be performed on the Satellite Terminal.
5. Prior to the change of cashier status (Normal cashier
→
Training cashier, or Training cashier
→
Normal cashier), daily reports and GT reports of this cashier should be taken.
OPERATION
CONDITION
Max. 12 characters
(See
NOTE 2 below.)
(See NOTE 1 below.)
Repeat for another
cashier.
Address 1: Cashier Name
Address 2: Cashier Status
0: Cashier for sale entries
1: Cashier for training entries (
NOTE 3)
For sequentially programming the address,
the Address number specification can be skipped.
(To complete this submode.)