Please note:
the centers of pedals magnet and wheel magnet shall be aligned with corresponding
induction part of sensor and shall not be deviated from it too far; the magnets shall not be more than 2
cm from the induction part, since distance larger than 2 cm will make it fail to receive the wheel spinning
signal. Screws can be loosened with screwdriver to adjust the distance between the extendible arm of
inductor and spoke magnet.
III. Production Application
1.
Speed/Cadence Sensor
Ⅰ
. There is a CR2032 button cell inside the product to provide power and its service life is 4 months in
general. Teasi Core or Tuhuna will fail to detect sensors when sensor cell is dead or sensor is damaged.
Sensor cell can be replaced according to the figure below;
Please note:
when you use this product for the first time, please remove the battery hatch to remove the
insulation film;
Ⅱ
. This product can be connected to any equipment conforming to BLE4.2 standard protocol and
transmit data to it; however, equipment conforming to Bluetooth standard protocol or subject o access
name restrictions are not included;
Ⅲ
. This product will get into sleep mode after wheels stop spinning for 5 min in order to save power; it
will also get into sleep mode when Tuhuna or Teasi disconnects with sensor. When it is used again, bike