24
NOTE
1
When "No INK Ribbon" or "No TFR Ribbon" is displayed and you find the corresponding ribbon is
fully consumed, be sure to change it.
(Attention: Do not close the side door without changing a fully consumed ribbon, or a tape that
holds the ribbon shaft and the ribbon itself in place would be peeled off and thus the ribbon might
get stuck in the mechanism, likely causing the printer to go out of order.)
NOTE 2
If you load a re-transfer ribbon rewound by the length of more than one disc (Figure 1), "ERROR
TFR Ribbon End" is displayed even not at the end of the ribbon.
If this is the case, perform the following (refer to Section 12 when necessary):
Step 1.
Open the side door.
Step 2.
Unlock the ribbon cartridge by flipping up the lock lever and take out the re-transfer
ribbon.
Step 3.
Wind forwards the ribbon to get the dyes transferred portion passed by, as shown in
Figure 2. (If there is no unused portion remained, replace the ribbon.)
Step 4.
Put the re-transfer ribbon cartridge back to its place and flip down the lock lever.
Step 5.
Close the side door.
Figure 1
Figure 2
