409-32043
Rev. D
11
of 11
TROUBLESHOOTING
1. Verify that the battery is operational.
2. Verify that the battery is charged. Re-check the battery after several minutes to ensure that the battery
is holding its charge.
3. Use a nonflammable contact cleaner or a pencil eraser to clean the electrical contacts on the battery
and crimping tool.
4. Re-install the battery and check the crimping tool again.
Refer to Table 4 for problems, probable causes, and remedy.
Table 4: Troubleshooting
Problem
Probable cause
Remedy
Tool is inoperative
Dirt or contaminants in the ram area of the tool. Return the tool to TE for evaluation.
Tool battery contacts are damaged.
Return the contacts.
Tool components are worn or damaged.
Return the tool to TE for evaluation.
REPLACEMENT AND REPAIR
DANGER
To avoid personal injury,
always
remove the battery from the tool
before
performing any maintenance on the crimping tool.
Kit replacement parts are listed in Table 5. Stock and control a complete inventory to prevent lost time when
replacement of parts is necessary. Order or return parts through your TE representative. You can also order
parts by any of the following methods:
Go to
Shop TE
link at the top of the page.
Call 800-522-6752.
Write to:
CUSTOMER SERVICE (038-035)
TE CONNECTIVITY CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair services, call 800-522-6752.
Table 5: Kit replacement parts
Part number
Description
2280381-1
Battery
2280381-2
2280382-1
Charger, 120 V, North America
2280382-2
Charger, 220 V, Europe
REVISION SUMMARY
Converted to current Customer Manual format.
