TCS900004, Rev.4
07/12/2016
Check us out at
www.TCSmeters.com
Page 29
Drive Components
Removing the Dust Cover
1)
Cut dust cover seal. Remove the dust cover screws with a standard flathead screwdriver.
2)
Note the setting on calibration adjuster.
3)
Note the position of the drive gear (either above or below the packing gland pinion).
Removing the Adjuster
1)
Loosen the retaining screws using a standard flathead screwdriver.
2)
Slide the retaining clip up and over to the right side.
3)
From the top, remove the screws to adjuster plate.
4)
Lift adjuster out of the counter adapter.
5)
Remove the adjuster drive assembly.
2
3
1
1
2
3
4
5
