TCL FC060BW2510GR, Owner'S Manual

Page: 11 / 61

Install Washing Machine
Remove tra nsit bolts
Before using this washing machine,transit bolts must be removed from the
backside of this machine.Please take the following steps to remove the bolts:
Keep the transit bolts properly for futher use.
1.Loosen the four transit bolts
with a spanner
2.Take each bolt head and pull it through the
wide part of the hole.Repeat for each bolt.
3.Fill the holes with the
supplied plastic covers.
■ Level the washing machine
Install or place the washing machine under the environmental temperature of not
less than 0 ºCbut not outdoors, for it may damage the programming controller.
Base foot structure
Factory status
Lock nut
Support foot covered
with rubber
Locking nut close to
bottom of box
Supporting foot close
to locking nut
Note:in order to facilitate installation,the factory stutus of the foot may not be all
locked,please be sure to lock all four feet before adjusting the level!
1.When pairing the machine,check
whether the bottom foot is in the factory
state.if not,please restore the bottom foot
to the factory state:the locking nut is
locked tightly on bottom of the box,and
the support foot is locked tightly on the
locking nut:
2.After the machine is placed,press the
opposite corner of the top cover plate of the
washing machine with both hands in turn
and shake it vertically downward to check
whether the supporting foot is close to the
ground and whether the machine is shaken
3.To ensure that the machine is placed in the right
state, loosen the locking nut according to
thedirection shown in the diagram with the
attachedspanner to the appropriate height until the
supporting foot is close to the ground and the
machine is free from shaking
Support base is close
to the ground
4.Finally,use the spanner to turn the lock nut
back to thebottom of the box to lock it(you can
also slightly fix the support foot by hand to avoid
the support foot moving again)
Ensure that the supporting
feet do not move again
CAUTION
1.The machine must be perfectly leveled and stabilized when the four supporting feet are close to
the ground. Lower the feet as much as possible on the basis that the machine is leveled.
2.Improper leveling adjustment may cause loud noise, machine vibrating, machine displacement
and other abnormal phenomena.
3.Air-vent is designed on the bottom of the machine (prevent blockage). Install the washing
machine on solid, smooth and skid-proof ground. Do not place the washing machine on soft
blanket or wooden floor, or various desktops and stands, in case of unnecessary injury.