TCL FC060BW2510GR, Owner'S Manual

Page: 12 / 61

Install Washing Machine
Connect the inlet hose
1.Connect the inlet hose to tap and fasten it
anticlockwise.
Ÿ
If there is any leakage with hose after
the connection,then repeat the steps to
connect inlet hose.
Ÿ Do not bend the hose.
Ÿ
Check for inlet hose connection
carefully before using the washer each
time.
Ÿ
The drain hose shall be placed at a
height of 65-100cm above the floor,
otherwise,it can cause poor drainage
Ÿ
You can use the supplied drain hose
support bracket to loop the drain hose
down into the wall,standpipe or laundry
tub.
Ÿ
Take care to ensure all hose
connections are tight.
Ÿ
The end of the drain hose cannot be
immersed in water for the washer to
work properly.
2.Connect the other end of the inlet hose to the inlet valve at the backside of the
washing machine and fasten the hose tightly clockwise.when there is a inlet at
the back of the machine,it must be connected to a cold water supply.If there
are two inlet valve,one is connected to a cold water supply and the other is
connected to a hot water supply. Follow the indication of the picture below to
complete the connection.
■ Connect the drain hose
inlet valve for cold water
inlet hose for cold water
inlet valve for hot water with a red grid
inlet hose for hot water with a red side
NOTE
NOTE