9
Network Settings
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or
wireless connection.
Connecting to a Wired Network
1.
Press
on the remote control, select
Network > Wired settings
and press
OK/►
to enter.
2.
Check the network information or enter
IP settings
to set the
IP address
,
Subnet mask
,
Default gateway
and
Primary DNS
values manually. Then press
▲
/
▼
/
◄
/
►
to select
OK
and press
OK
to confirm. The TV set will try
to connect to the network and inform you about the result.
3.
Press to return to the
Network
menu.
4.
If you want to check the Internet connectivity, press ▲/▼ to select
Connecting test
and press
OK/►
.
Connecting to a Wireless Network
Your TV is equipped to be connected to your home network wirelessly. To do that you need a wireless router or
modem.
1.
Press
on the remote control, select
Network > Wireless connection> Wireless connection
and press
OK/►
to enter.
2.
Press
▲
/
▼
to select
On
and press
OK
to confirm.
3.
You can set the wireless network connection in 3 ways:
-
a) Scan
• When
Wireless connection
is turned on, the TV will search all access points within range. Access points
found by the TV will be displayed.
• Press
▲
/
▼
to select an available access point, then press
OK/
►
to connect.
• Select
All wireless
(if available) to find more access points.
Note
: If you select a protected access point, you will have to enter the corresponding password. Press
OK
on the
remote control to display the virtual keyboard to enable you to enter the password.
-
b) Manual
Press
▲
/
▼
to select
Manual
and press
OK/
►
to enter. You will be prompted to enter the correct SSID of an
available wireless router, select its security tytpe and enter the password (if needed) to set up the connection.
-
c) Auto
If your AP (Access Point) supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN
(Personal Identification Number) or PBC (Push Button Configuration). WPS will automatically configure the
SSID and WPA key in either mode.
Press
▲
/
▼
to select
Auto
and press
OK/
►
to enter.
•
PIN
: Select
PIN
and press
OK/
►
to enter. Choose a random PIN code. Make sure this code is installed on the
AP. (For the procedures, refer to your router manual.) Select
OK
and press
OK
to set up the connection.
•
PBC
: If your router has a PBC push button, select
PBC
and press
OK/
►
to enter. Press the PBC push button
on your router within 2 minutes before you select
OK
and press
OK
again. Your TV will automatically acquire
all the network setting values it needs and connect to your network.
- Press
to return to the
Network
menu.
4.
If you want to check the Internet connectivity, press ▲/▼ to select
Connecting test
and press
OK/►
.
Chapter 2
Getting Started
