TC Electronic G-System, User Manual

Page: 50 / 81

The G-System has two stereo jack connectors which
give you access to four relays. Use them to switch
channels on your amp or pre-amp.
Relay Switching Menu
• Press EDIT and turn PAGE to select RELAYS.
• Press ENTER.
A and B Settings
For each preset, you can define two relay configurations
can be set up .
Having two positions allows you to alternate between two
amp channels using an assigned switch while staying in
the same preset.
Relay
The options are A and B. This parameter sets whether
the preset should select relay combination A or
combination B at preset change.
The options on each connector are:
–
Open
– Tip to Ground
– Ring to Ground
– Tip and Ring to Ground
The following options are available:
1 OOOO 9 COOC
2 COOO 10 OCOO
3 OCOO 11 OCCO
4 CCOO 12 OCCC
5 CCCO 13 OCOC
6 CCCC 14 OOCO
7 COCO 15 OOCC
8 COCC 16 OOOC
O = Open
C = Closed
>> EFFECT COPIED <<
EDIT A EDIT B EDIT C
>> PRESET STORED <<
EDIT A EDIT B EDIT C
A : B : Relay
EDIT A EDIT B EDIT C
0C00 : 0C0C : A
RELAYS – FOR AMP CHANNEL SWITCHING
48
- Utility continued
Example: You have a 2 channel amp and would like use
on of the switches on the G-System to switch between
these channels. At the same time you would like to avoid
that the G-System sends out the Relay settings stored
with presets at preset recall.
• On you current preset; set Rel.A and Rel.B to two
positions that switch the two channels on your amp.
This is done via the Edit->Relays menu.
• Set Relay Lock to “ On” via the Utility menu.
• Assign a switch to “Relay” via the Edit->Switches
menu.
Routing Lock
Range: On/Off
With routing lock set to on the current routing us used on
all presets. Note that you may need to make minor level
adjustments to certain presets.
Factory Bank Lock
Range: On/Off
When this parameter is set to “on” the factory banks
cannot be accessed.
View Angle
Adjusts the backlight of the LCD for better viewing
comfort.
Clear System
Resets all System and I/O settings to factory defaults.
User presets are left unaltered.
Clear Bank
Deletes all presets in the user bank. All system
parameters are left unaltered.