TC Electronic G-System, User Manual

Page: 27 / 81

Pedals and Head
PUSH
Drive Pedals
TAP TEMPO
EDIT PARAMETER B EDIT PARAMETER C SELECT PAGE EDIT PARAMETER A GAIN ADJUST
HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE
PRESETABLE BOOST LEVEL
LEVEL SET
EDIT A EDIT B EDIT C
GLOBAL TEMPO
FORMANT | WAH | EFFECT FILTERS COMPRESSOR ALGORITHM
MODE MENU WHAMMY | PITCH ALGORITHM CHORUS | FLANGER | TREMOLO
| RETURN ENTER
HI-CLASS | TAPE ECHO | DYNAMIC REVERB ALGORITHM
INPUT DAMP
EDITED
COM FLT PIT DLY REV
E1: E2: E3: E4: E5:
INTEGRATED EFFECTS
+MANAGEMENT
FILTER LOOP LOOP LOOP EDIT 1 2 3 COMP
UP
DOWN
MOD PITCH DELAY REVERB BOOST
ENCODER ENCODER ENCODER ENCODER ENCODER ENCODER
Send R
etur
n
Send R
etur
n
Send R
etur
n
Send R
etur
n
Loop 1
Expression
P
edal
Loop 2 Loop 3 Loop 4
Expression/V
olume
P
edal
Out Insert
Guitar Input
Send R
etur
n
Send
Input
HEAD
Return
CAB
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
Connecting
• Connect your guitar to the G-System’s Instrument
Input.
• Connect up to four drive pedals to the loops.
• All pedals connected to the loops must remain
switched on at all times.
The G-System
activates/deactivates the loops – not the pedals!
• Connect expression pedals using a single standard
1/4" jack cable. Depending on the expression pedal
model, the cable must be mono or stereo.
• Connect the G-System’s “Insert Send” to the head’s
input. Connect the head’s effect loop send to the G-
System’s “Insert return”.
• Connect the G-System’s “Out” to your amp’s effect
loop return (“power-amp in”). Use two amps for
stereo operation.
• Connect expression pedals and calibrate these using
the Pedals menu.
In this setup we are using a head as both pre-amp and
power amp. The pre-amp section of the head is
connected to the G-System’s Insert loop. Set the Insert
loop to “on” on all G-System presets, using the Utility
menu.
Look at the illustration and see if you can follow the
signal chain:
•
Connect your guitar to the G-System’s Input.
• Up to four pedals can be connected in loops 1 to 4.
• Via the Insert loop’s “Send”, the signal is sent to the
head’s input.
• The head’s pre-amp out/send goes to the G-System’s
Insert loop “Return”. This way, the entire signal from
the drive pedals and the pre-amp section of the head
is returned to the input of the G-System’s effects
section.
• Via the G-System’s Out Connector, the signal is sent
to the head’s return – which is actually the input of
the head’s power-amp section.
TYPICAL SETUPS
25