TBS Installation Manual
–
3D FLASH+
TBS 3D FLASH+ Mounting and Installation Guideline
•
TBS-061
•
Rev 11-2023
page 6 of 17
3.3
Choose the Installation Type
▪
Installation can be accomplished by mounting directly to a wall (surface mount).
You can choose your installation type from two versions: with or without backunit.
▪
A backunit is included in each package (first picture from the left below).
When using it, first the backunit is mounted to the wall.
Then the metallic wall plate is mounted on top of it, and the 3D FLASH+ can be secured back on it
using the two bottom screws. The reader will then protrude further from the wall, allowing for
ventilation.
This version is recommended if a further upgrade with the fingerprint sensor module could be
considered by the customer.
▪
The metallic wall plate can also be mounted directly on the wall, resulting in an installation as in
the picture to the right above. On a flat surface, this installation looks slimmer, as the device then
only extends 25 mm from the wall.
▪
The delivered package includes all required connection cables and mounting screws:
The 4 long screws are for mounting the backunit or wall plate to the wall
The 6 short screws are for mounting the wall plate on the backunit
The 2 metal thread screws are to secure 3D FLASH+ on the wall plate
The 2 distance screws are to mount an optional thermal sensor (not supported)
