TBS Installation Manual
–
3D FLASH+
TBS 3D FLASH+ Mounting and Installation Guideline
•
TBS-061
•
Rev 11-2023
page 7 of 17
3.4
Direct Installation to Wall (without Backunit)
▪
Place the installation plate on the desired wall location and screw it into the wall as indicated in
the Surface Mount diagram below. Please ensure that the bottom tab in the plate faces outward
into the room and the cable routing opening in 3D FLASH+
(marked in green)
matches the
opening in the wall. Utilization of wall anchors is mandatory.
▪
To mount 3D FLASH+, slide the 3D FLASH+ into the wall plate from the top.
▪
Lock the 3D FLASH+ using the two M3 x 6mm screws on bottom. If required, replace the screws
with security type screws.
Backside view with wire connection
pass through (power and LAN)
Front view of wall plate as mounted to the wall with
outline of the reader. The bottom tabs face away
from the wall. Lower edge of the reader is 3 mm
lower than the lowest point of the plate.
Heads of the mounting screws should not protrude
more than 5 mm from the wall plate and not be larger
than 8 mm in diameter.
