Operating instructions TBi PP-TX welding torch
TBi Industries GmbH
Page 54 / 63
Subject to change without notice.
2020 TBi Industries GmbH
)
4 Product operation
Follow all instructions from section 3 before the product can be put into operation
4.1 Normal operation:
Start-up
Danger!
Before starting up the system, the entire installation must be inspected in accordance with
the manufacturer’s instructions and the applicable safety regulations.
The safety instructions at the beginning of this operating manual must be observed!
Please check the following to make sure that the system has been installed correctly:
1. Are all parts bolted tightly? (see section 3.3)
2. Has the torch neck been fastened as described and correctly and fully equipped?
3. Is the Euro central connector or direct connector fastened tightly? (see section 3.5, 3.6)
4. Has the wire guide been selected and installed according to specifications?
5. The wire run-in can now be started. (see section 4.3)
6.
Has the spring tension for the
pressure roll been set
correctly? (see section 4.4)
)
7.
Is the adjustment of motor characteristics required and has it been performed accordingly?
(see section 4.5)
8. The TBi PP-TX welding torch is now ready for operation.
Take the necessary safety precautions before starting the welding process!
4.2 What to do in case of faults or maintenance
Danger!
Please observe the safety instructions at the beginning of this manual!
Damaged torches or cable assemblies must not be used anymore!
Known defects must be repaired by TBi Industries prior to the next use of the equipment
Danger of burn injuries!
Gas nozzle and torch head get very hot during welding. Let the torch cool down prior to
doing maintenance work!!
For safety reasons the following sequence is to be strictly followed:
1. Before performing maintenance on the system, the main power of the installation must be turned off.
2. Let the torch cool down prior to doing maintenance work (e.g. replacing wear parts)!
3. Eliminate fault (see section 7) or
perform maintenance (see section 5)
4. Turn on the main power of the installation.
5.
If necessary, perform the wire run-in
. (see section 4.3)
6. The TBi PP-TX welding torch is now ready for operation.
Summary of Contents for PP-TX
Page 32: ......
