TBi Industries PP-TX, Operating Instructions Manual

Page: 42 / 63

Operating instructions TBi PP-TX welding torch TBi Industries GmbH
Page 42 / 63 Subject to change without notice.

2020 TBi Industries GmbH
.
3 Preparing the product for use
3.1 Transport and storage
The following points must be observed during transport and storage:

To prevent danger due to the TBi PP-TX torch falling, only place it down on substrata that have a high
load-bearing capacity and are stable.

The ambient temperature specifications must be observed.
(see section 2.2)

Protect the TBi PP-TX torch from moisture and environmental influences.
Important note!
If the TBi PP-TX is transported and/or stored, the torch neck (1a) must always be installed
for a water-cooled system. Otherwise there is a danger that the cooling water could get
inside the torch.
3.2 Installation
The following points must be observed during installation:

Carefully remove the packaging; to prevent danger due to the torch falling, only place it down on
substrata that have a high load-bearing capacity and are stable.

Ensure that all TBi PP-TX torch components are present.
(see section 2.4)

Please observe all sections described below for additional servicing.
3.3 Preparation
Danger!
The supply voltage to the welding machine must be disconnected before starting installation
work. It must be ensured that the entire facility remains switched of for the duration of the
work. There is a risk of fatal electric shock.
You must observe the ‘Safety instructions’ at the beginning of this document.
3.3.1 Equipping the torch
The TBi PP-TX welding torch can be used for various welding tasks and filler materials. The accessories
integrated into the PP-TX must be individually adapted to each task in order for the torch to function properly
and to ensure optimum welding results. The necessary work steps are described below.