SETTING UP & WELDING
SETTING UP & WELDING
After setting the chuck, insert it into the pistol chuck
holder and push firmly home until it comes to a rest.
NOTE! When welding M10 studs or studs between
35 and 50 mm in length, the pistol will require longer
tripod legs fitting (see page 34).
Tighten the chuck locking nut with the box spanner
provided. A gentle pressure is all that is required.
Over tightening may result in damage to your pistol.
SETTING THE PISTOL
STANDARD CONTACT PISTOL
Set the pistol spring preload to the appropriate setting
for the welding task to be performed. (See the tables
on pages 16 - 26).
MkV LIFT GAP PISTOL
Set the pistol lift to the appropriate setting for the
welding to be performed (See the tables on pages 16 -
26.)
This is achieved by placing the pistol in the welding
position thereby pushing the tip of the weld stud back
level with the end of the tripod legs / nosecone.
Whilst the pistol is being held firmly in this position
twist the rear end cap of the pistol clockwise until the
motion becomes stiff.
12
Summary of Contents for SYSTEM CD200 SERIES
Page 44: ...EMC CERTIFICATE 42...
