25
Model H60
Operating Procedures
Locate the spinner coupling and slip it over the slotted
end of the spinner blade shaft. Raise the slip collar on
the coupling and turn the shaft until the spinner
coupling slips down into its locking position.
Figure 16
Step 9
Rotate the draw valve to the left, and center it in
position on the draw arm. Place the valve in the slotted
groove of the draw valve bracket.
Figure 17
Step 10
Position the torque arm by slipping it up through the
slot in the operating arm, and then down into the hole
in the torque rotor shaft. Check the torque arm by
moving it back and forth to be sure it moves freely and
easily.
Step 11
Connect the syrup lines of the spinner housing to the
quick disconnect fittings on the front panel.
Figure 18
Step 12
Install the front drip tray and splash shield.
Figure 19
Step 13
Slide the three o- rings into the grooves of the inner air
tube.
Figure 20
