23
Model H60
Operating Procedures
150626
Figure 6
Insert the torque rotor, plastic guide bearing end first,
making sure
that it fits into the hole in the beater drive
shaft. Rotate it several times to check for proper
positioning.
Figure 7
Step 4
Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear:
door bearing, door gasket, draw valve, o- rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
Step 5
Lubricate the plastic spinner bearing. Insert the plastic
spinner bearing into the top of the draw valve.
Figure 8
Slide the two o- rings onto the draw valve and
lubricate.
Figure 9
Lubricate the inside of the door spout, top and bottom,
and insert the draw valve into the freezer door from the
top. It will be necessary to rotate the draw valve to the
right when installing the door on the freezer.
Figure 10
