![background image](http://html.mh-extra.com/html/taylor-made/kw-series/kw-series_manual_823342006.webp)
6
Rev: 02.18.21
CCD-0004215
Fig.5
Fig.6
6.
Based on the outer diameter of the ski bar, determine which set of
machine screws to use to attach the lower clamp brackets to the mount.
Size options include: F1, M10x35; F2, M10x55; and F3, M10x70.
7.
Orient the mount so the top leading edge of the angled portion faces
out
(Fig.5)
.
8.
Using the correct machine screw length, insert all four machine
screws through holes in the base of the mount
(Fig.6)
.
9.
Hold one lower clamp bracket underneath and finger tighten two
machine screws into the clamp bracket. Repeat this step for the
remaining bracket.
10.
Finish tightening the four machine screws using the included hex
wrench. Tighten firmly but do not overtighten.
Note:
Tighten the machine screws evenly so the gap between the
base of the mount and the lower clamp brackets is the same on both
sides as well as the front vs. the back (Fig.6A). The gap should be
the same size to ensure it is properly mounted.
A
facing
out
(toward
water)
facing
in
(toward
boat)