7
CCD-0004215
Rev: 02.18.21
operation
1.
Choose the proper inner diameter size of the rubber compression
insert that fits the outer diameter of the flagpole:
3/4
”, 1” or 1
1/4
”.
Note:
The sizes are included on the bottom of the rubber inserts.
2.
Place the compression insert inside the coupler so the four slots
on the rubber compression insert are aligned with the four slots in the
flagpole coupler
(Fig.7)
.
Note:
Make sure to push the insert flush with the bottom of the
coupler.
3.
Slide the flagpole through the hand knob
(Fig.7A)
.
4.
Place the flagpole into the insert and coupler and thread the knob
onto the coupler
(Fig.8)
.
5.
Tighten firmly by hand but do not overtighten.
6.
Pull the flagpole upward with slight pressure to ensure it is properly
fastened inside the coupler. The flagpole should not move upward.
square
rain drain
aligned
with
round
rain drain
Fig.7
Fig.8
A