Taylor-Dunn SS-025-34, Service And Parts Manual

Page: 60 / 134

Drive Motor
Page 60
SS and MX Models, DC System
MS-534-13
MOTOR REMOVAL AND INSTALLATION
See the Transmission section for information on removing or installing the motor.
DISASSEMBLE
1: Remove the motor from the
vehicle. See the Transmission
section for information on
removing the motor.
2: Remove the bolts holding the front
housing and press the armature
out of the housing.
3: Remove the bearing circlip,
bearing, and seal from the front
housing.
4: Remove the brush cover and pull
the brushes out away from the
commutator.
5: Remove the dust cap from the rear motor housing.
6: Place the motor in a press, and press the armature out of the rear bearing.
Note: Removing the armature will damage the motor bearing. The motor bearing should be replaced whenever
the armature is removed from the rear housing.
7: Remove the housing screws from the rear motor housing and remove the housing from the motor.
8: Remove the nuts from the armature studs and remove the two brush assemblies.
9: Remove the bearing circlip and press the motor bearing out of the housing and discard.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING