Taylor-Dunn SS-025-34, Service And Parts Manual

Page: 43 / 134

Steering
Page 43
MS-534-13
SS and MX Models, DC System
FRONT FORK
Installation
Note: It is recommended to replace the grease
seal any time the fork is removed from the
vehicle.
1: The front of the vehicle should be supported on
jack stands just high enough to install the fork.
2: Place the lower bearing in the fork collar and
install a new grease seal.
3: Apply a light coat of grease to the collar bearing
races.
4: Insert the fork up through the fork collar and lower
bearing being careful not to damage the grease
seal.
5: Hold the fork up in the collar and install the upper
bearing, washer, and spindle nut.
6: While rotating the fork to the left and right, torque
the spindle nut to 110 foot pounds.
7: Loosen the nut 1/4 turn and then re-torque to 70
foot pounds.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING