Taylor-Dunn B0-011-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 70 / 180

Curtis PMC Troubleshooting
Page 4
Definitions:
•
“MS-1” = The first switch in the accelerator module.
•
“Battery volts” = The voltage at the batteries at the time the test is completed.
•
“Pick up” = Energizing a solenoid or contactor.
•
“F&R” = Forward and Reverse.
•
“ISO” = Isolator.
•
“Battery negative” = Main negative battery post.
•
“Battery positive” = Main positive battery post.
•
“PMC” = Speed control module (black box).
•
“HOT terminal” = The side of a switch or solenoid that is connect to the power source.
•
“COLD terminal” = The side of a switch or solenoid that power is switched to.
DURING ALL TESTS
START:
Read all warnings above before continuing.
If the vehicle runs normal in one direction but does not run in the opposite direction then go to
the
Solenoids sequence.
If none of the three solenoids pick up (click) when the accelerator pedal is depressed then go
to the
Forward & Reverse Switch sequence.
After any repairs are made, completely retest the vehicle before
lowering the drive wheels to the ground. Failure to retest the vehicle
could result in unexpected movement of the vehicle resulting in
severe bodily injury and/or property damage.
The rear drive wheels may rotate during some of the following tests.
Block the front wheels, raise the rear drive wheels off the ground,
and support the vehicle with jack stands. Failure to do so may cause
the vehicle to move and cause severe bodily injury and/or property
damage.
Rotating rear drive wheels are a potential hazard. Keep hands, arms,
legs and loose clothing away from the rear drive wheels while
conducting tests. Failure to do so may cause serious bodily injury.
Disconnect both of the battery leads during any maintenance or
before disconnecting any electrical component or wire. Failure to do
so may cause severe bodily injury and/or property damage.