Taylor-Dunn B0-011-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 45 / 180

MB-100-00
Section 3 Page 23
Removal and Installation of the Steering Gear Assembly
6. Raise the front of the vehicle and support with jack stands.
7. Remove the pinch bolt.
8. Disconnect the drag link from the pitman arm.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in serious bodily injury.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
9. Remove the three bolts connecting the steering gear to the
steering column and remove the steering column from the vehicle.
Drag Link
P i t m a n
Arm