Taylor-Dunn B0-011-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 32 / 180

MB-100-00
Section 3 Page 10
Replacing the Brake Shoes
6. Raise the rear of the vehicle and support with jack stands.
7. Using the appropriate procedure, remove the brake
drum.
8. Release the park brake.
9. Remove the tension springs.
10. Remove the hold down springs.
11. Remove the auto-adjust lever spring.
12. Apply this procedure in reverse order to install the
new brake shoes.
NOTE: Be sure all the parts are thoroughly
cleaned.
NOTE: Be sure that the anchor points on the
brake shoes are given a light coat of
hi-temp grease.
13. Lower the vehicle.
14. Reconnect the main positive and negative at the
batteries.
15. Remove the blocks from behind the wheels.
16. Test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in serious bodily injury.
Do not allow grease to
contact any of the braking
surfaces. Braking surfaces
contaminated with grease
may cause the brakes to fail
resulting in property damage
and/or severe bodily injury.