Taylor-Dunn B0-011-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 40 / 180

MB-100-00
Section 3 Page 18
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in serious bodily injury.
Centering the Steering Gear
6. Raise the front of the vehicle and support with jack stands.
7. Turn the steering gear all the way to the left.
8. Turn the steering gear back three turns and secure it so it can not move.
9. In order to align the wheels, adjust the drag link.
10. Lower the vehicle.
11. Reconnect the main positive and negative at the batteries.
12. Remove the blocks from behind the wheels.
13. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Typical steering gear and pitman arm