16. On the rear of the handle is a handle stop
that sits against the right hand side of the valve
temperature stop ring to prevent the handle
being rotated past the pre-determined maximum
temperature position. Without moving the
temperature spindle, position the handle onto the
cartridge so that it cannot rotate anti-clockwise.
Note: Do NOT remove the temperature stop ring
to make adjustments as this will prevent correct
assembly later.
17. Once installed, the handle should click as it
rotates. This click can be adjusted to give more
feedback when in use.
Rotating the feedback screw clockwise will
make the pin stiffer and the click will be more
noticeable - rotating the screw anti-clockwise will
loosen the pin and soften the click.
Figure 21
Figure 20
Feedback Screw
Handle Stop
