12. Lift the valve and push the hoses back through the access hole, making sure the hoses do not kink
(Figure 14). Position the valve flat against the tiles and line up the fixing holes with those on the metal
installation frame. Secure the valve to the fixing frame.
Note: Tighten fixing screws with a screwdriver to prevent over-tightening. Do not use an electric
driver as this may damage the valve housing or cause it to warp, preventing correct installation. If
the housing flange is not flat against the wall surface, the fixing screws are too tight.
You are now ready to install the cover plate and valve controls.
13. When secured in place, the fixing nuts of the flexible hoses will be visible above the valve housing.
This will allow the connections to be checked for leaks and for the hoses to be tightened slightly, if
necessary, without removing the entire valve.
Figure 14
Housing Flange
Figure 15
