Taurus V302T, Manual, Page: 43 / 140

Boil over, melts,
and hot sugary
spills on the glass
Remove these immediately
with a fish slice, palette knife
or razor blade scraper suitable
for ceramic glass of hob, but
beware of hot cooking zone
surfaces:
1. Switch off the power supply.
2. Hold the blade or utensil at
a 30° angle and scrape the
soiling or spill to a cool
area of the hob.
3. Clean the soiling or spill up
with a dish cloth or paper
towel.
4. Follow steps 2 to 4 for
‘Everyday soiling on glass’
above.
• Remove stains left by melts and sugary
food or spill overs as soon as possible. If
left to cool on the glass, they may be
difficult to remove or even permanently
damage the glass surface.
• Cut hazard: when the safety cover is
retracted, the blade in a scraper is razor-
sharp. Use with extreme care and always
store safely and out of reach of children.
Spill overs on the
touch controls 1. Switch off the power supply.
2. Soak up the spill
3. Wipe the touch control area
with a clean damp sponge
or cloth.
4. Wipe the area completely
dry with a paper towel.
5. Switch on the power supply
to the hob.
• The hob may beep and turn
itself off, and the touch controls may not
function while there is liquid on them.
Make sure you wipe the touch control
area dry before turning the hob back on.
Maintenance of the Hob
If you find something goes wrong for your hob, before contact the service or where you
purchased it, please check whether below:
1. There is no power to the appliance:
- Check whether there is a power cut of your department;
- Check whether the appliance be connected to electricity properly;
- Has the timer setting elapsed;
- Whether it reaches the longest cooking time setting and auto shut off;
- Whether there is liquid boiling over touch control panel and overflow protection devices auto shut off;
2. The touch control panel buttons can’t be active:
-
Whether it’s under “Child Lock”, which there is “Lo” shows in timer displayer;
- Whether liquid/wet cloth over touch control panel active overflow protection;
3. After cooking there is “H” shows on display: