ULTRA TRAINER
14
3.2
Assembly instructions
Before starting assembly, look carefully through the individual assembly steps
shown and assemble the equipment in the order indicated.
Step 1:
Be careful while unpacking
(1)
Place the box flat on the floor and remove the
upper box at first.
(2)
Lift the main frame and remove the styrofoam.
Place the main frame on an even floor.
Note:
For safety reasons, removing the main frame
and the assembly itself should be done by at least
two persons.
A
A
Z2
PAPER TUBE
6 m/m
5 m/m
Z1
J2
Step 2:
Preparation of the assembly
(1)
Remove the four pre-mounted screws
(Z2) from the paper roll (Z1). Repeat this
step on the other side.
(2)
Remove the pre-mounted screw (J2)
and the paper roll.
Note:
The J2 screws are required for the
following assembly. However, the parts
Z1 and Z2 are no longer required.
A
A
Z2
PAPER TUBE
6 m/m
5 m/m
Z1
J2
