Taurus BodyCraft SEBR6245, Assembly Instructions Manual

Page: 16 / 36

16
HFT
Step 3: Assembly of the Guide Rods
1. Insert two plastic guide rod holders (24) into the outer holes of each of the base frame legs (1L
& 2R).
2. Insert two guide rods (5) into the plastic guide rod holders (24).
࣑
ATTENTION
The stack spacers (23) must only be installed if you have 28 weight plates/14 per side. If you have
38 weight plates/19 per side, do not install the stack spacers (23) in the following step.
3. Slide two stack spacers (23) and two rubber donuts (22) over the guide rods (5).
4. Attach the selector rod (20) to the top plate (19) with the top plate bolt (48), tighten.
5. Thread the pulley block (18) into the selector rod (20) minimum 1/3 of the way (Fig. A).
L
NOTICE
Make sure to orient the selector holes of the weight plates toward the inside bottom.
6. With the guide rods slightly angled (Fig. B), carefully slide each of the weight plates (21) over the
guide rods (5) one by one.
7. Slide the top plate (19) over the guide rods (5), running the selector rod (20) down through the
center holes of the weight plates (21). Insert the selector pin (41) into one of the selector holes.
8. Place the top guide rod holders (14) onto the guide rods (5) and secure to the top of the left top
frame (6L) with the two pre-installed hex socket dome bolts (56) and two 5/16” washers (64).
9. Tighten the two pre-installed set screws (60) and hex dome bolts (56).
10. Repeat the steps 1 to 9 on the other side.