Taurus BodyCraft SEBR6245, Assembly Instructions Manual

Page: 18 / 36

18
HFT
Step 4: Assembly of the Cables and Pulleys
L
NOTICE
+ The following steps show the assembly on the right side of the equipment. The steps must
be repeated for the left side as well.
+ The cables and pulleys must be installed simultaneously.
1. Fasten the ball end of the cable (27) to the pulley holder (17) with two Pulleys P1 and P2 (36)
with a total of two 3/8” X 1-3/4” hex bolts (53) and two 3/8” black nylon nuts (69) [Fig A].
2. Route the cable (27) over the two pulleys P3 and P4 and mount pulley P4 to the right top frame
(6R) with one 3/8” X 4” black hex bolt (51), two 3/8” black washers (63) and one 3/8” black nylon
nut (69) [Fig B].
3. Route the cable (27) down through the pulley block (18) and around pulley P5. Mount the pulley
P5 to the pulley block (18) with one 3/8” X 1-3/4” hex bolt (53) and one 3/8” black nylon nut (69)
[Fig C].
4. Route the cable (27) up over the pulleys P6 and P7 (36) through the right top frame (6R). Mount
the pulleys P6 and P7 to the right top frame (6R) with a total of two 3/8” X 4” black hex bolts (51),
four 3/8” black washers (63) and two 3/8” black nylon nuts (69) [Fig B].
5. Route the cable (27) down through the pulley holder on the base frame leg and around pulley
P8 (36). Mount the pulley to the pulley holder using one 3/8” X 1-3/4” hex bolt (53) and one 3/8”
black nylon nut (69) [Fig. D].
6. Route the cable (27) up and screw the bolt end of the cable (27) at least 1/3 into the bolt holder
that is welded onto the right pulley height adjuster (15R) [Fig. E].
7. Repeat the steps for the left side.
L
NOTICE
If necessary, the cables can be tightened or loosened by adjusting the screw conntections on
the height adjusters (15R & 16L) [Fig. E] or on the pulley blocks (18) [Fig. C].
8. Tighten all jam nuts firmly [Fig. C & E].