Taurus BodyCraft SEBR6245, Assembly Instructions Manual

Page: 12 / 36

12
HFT
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Assembly of the Base Frame Legs and Rear Upright Frames
1. Carefully attach two end caps (38) to each of the base frame legs (1R & 1L).
2. Attach the rear upright frames (4) to the right & left base frame legs (1R & 1L) with the eight pre-
installed 3/8” chromed washers (62) and 3/8” chromed nylon nuts (68).
3. Attach the top cross support (8) to the rear upright frames (4) with four 3/8” X 2-1/2” hex bolts
(52), eight 3/8” chromed washers (62) and four 3/8” chromed nylon nuts (68).
4. Attach the bottom cross support (9) to the rear upright frames (4) with four 3/8” X 2-1/2” hex
bolts (52), eight 3/8” chromed washers (62) and four 3/8” chromed nylon nuts (68).