82
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
E
E
E
E
Front loader assembly (PD)
1. Couple the blade on the support (A) using the stud bolt (B), flat washers and nuts.
2. Couple the adjusting support (A) on the hole on the rear part of the moving support
(C) and on the hole on the front part of the adjusting support (A), locking with pins
(D).
C
C
B
B
A
A
D
D
3
3
2
2
1
1
5. Assembly
3. When the equipment is operating with
the blade, use the side holes (1 and 3)
to give a right or left angle on the blade.
4. When the blade is operating with an
angle, remove the rods (E).
5. Adjust the angle using the bolt (B) to
reach the desired angle.
6. The rods (E) are used only when the
blade is coupled to the central hole (2)
and also on the DE (refuse raker). Do
not use the rods along with the other
optional parts.