76
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
5. Assembly
Hoses connection system
1. To finish the assembly, couple the male parts along the quick coupler nipple fittings
on the hoses (A) from the moving support, coupling them to the female output on
the tractor.
- The rear outputs (B) may change due to the tractor brand and model.
NOTE
A
A
B
B
2. Inspect the sealing rings on the quick
couplers. Replace them if there is any
leakage.
3. Before coupling the equipment hoses, clean
the quick coupler surface.
4. The hoses coupling is done by pushing the
quick coupler (male) into the connections
(female) until the locking occurs. The
uncoupling is done by pulling the quick
coupler (male). This is the Push/Pull system.
ATTENTION! RISK OF ACCIDENT
- Do not carry out any repair when the system is pressurized.
- Use adequate eye and hand protection when looking for high-pressure hydraulic
leaks.
