99
GAPCR-HD 8013/GASPCR-HD 9017/GASPCR-EHD 10020 - Rev. 05 - Sep/22
8. Adjustments and operations
Cutting depth
Use the depth stops (A) to control the depth,
which are placed on the hydraulic cylinder (B) rods
and work as course limiters, thus providing several
adjustments of the disc blades cutting depth.
The cutting depth is adjusted through the following points:
1) Disc gangs opening
The opening angle should increase between the gangs to work in soils with greater
difficult to penetrate the disc blades. In light and loose soils, it is appropriate to work with
a smaller opening angle.
This adjustment is done by changing the setting of the disc gang carriers on the main
frame.
- Only
CAPABLE
and
AUTHORIZED
personnel must carry out the adjustments and
operations of the equipment.
- Observe every safety condition and use safety glasses, foot protection, earplugs/
muffs, protective gloves and any other required PPE.
- Do not carry out any adjustment while the equipment is working.
ATTENTION! RISK OF ACCIDENT
- We recommend the depth control by the disc gangs opening. Use the tires only where
the disk harrow penetrates excessively.
- Use the depth stops (A) to determine less depth when cutting with the disk harrow,
always maintaining the same adjustment of the cutting depth of the disc blades.
NOTE
Greater
Greater
depth
depth
Smaller
Smaller
depth
depth
Front
Front
gang
gang
Rear
Rear
gang
gang
B
A
Greater
Greater
depth
depth
