Installation Guide: PowerAire® Quad
r2.0-7/8/14
Quad- S: 16943, 17351 Quad- M: 16886, 16633 Quad- C: 17347, 17348
7510 Montevideo Road
© 2012 Tate Access Floors, Inc.
Jessup, MD 20794
Tel (410)799-4200
5 of 15
3.
A more flexible alternative method of attaching the unit to the raised floor understructure can also be
realized by the use of the corner cable hangers. These cable hangers shown in figure 5 below, can allow unit
to hang from the pedestal head in cases were non roll formed stringers are in use. It may be necessary to
install a screw in the pedestal head on which to hook the unit for hanging.
Figure 5 - Alternative Corner Lock Hangers
Figure 6 – Power Outlet from Site Source
4.
Each PowerAire®
unit must be powered from the appropriate outlet. For 100-120V and 200-240V
installations, a C14 power inlet is provided on the unit. The supply voltage of the unit will dictate the power
cord supplied with the unit, which will be 6’ feet in length, a list of the required power outlet is shown below
in table 1. If the supplied cord does not meet the site requirements, a use supplied cord set may be used if it
meets the voltage and amperage requirements of the power module. Figure 6 shows an example of a power
feed to the unit.
Table 1 - Power Feed Requirements for Unit
PowerAire® Power Feed
Requirements
Voltage
Outlet Required
100 - 120V
NEMA 5-15R
200 - 240V
NEMA L6-15R
5.
Pick up the PowerAire®
unit using the inside lip around the inside perimeter of the PowerAire®
unit. Be sure
to orient the units extended shroud below the rack. Lower the PowerAire
TM
unit at the edge that extends
beyond the perimeter of the unit first so that this edge will be oriented beneath the rack see figure 7 through
9 below. Lock the lip of the unit into the hanger, the lower the opposite side into the waiting Tool Less
hanger. Once this side is also resting in the hanger support, manipulated the unit so that each hanger on the
alternate sides are also secure the unit into place.
