97
FLAT TYRE REPLACEMENT
EMERGENCY & BREAK DOWN ASSISTANCE
07
CHANGING FLAT TYRE:
•
Block the wheel which is diagonally
opposite to the flat tyre.
•
Take out wheel cover (if fitted).
•
Slacken but do not remove the
wheel nuts before raising the vehi-
cle.
Front jacking point
NOTE
•
Do not lift the vehicle with some
one inside.
•
Make sure the jack is positioned
firmly on a level surface and
correct jacking point.
•
Never work under a raised
vehicle that is supported only by
a jack. This may cause a
personnel injury.
•
Never change a wheel on a slope;
otherwise the vehicle could slip
off.
•
Do not use oil or grease on studs
or nuts. Which cause the break-
age and slip of the wheel stud.
•
Do not start or run the vehicle
while supported by a jack.
•
Remove wheel-mounting nuts and
take out flat tyre.
•
Roll the spare wheel into position
and align the holes in the wheel with
studs.
•
Set the jack properly at correct
jacking point as shown for front or
rear wheel. The jacking points are
located approximately 185mm
from the front wheel and 260mm
from the rear. Slowly lift the vehicle
with the help of a jack handle.
Rear jacking point
Summary of Contents for INDICA VISTA
