TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
SOLUTION
Does not flush
a. Water supply valve is closed.
b. Supply line blocked.
c. Poorly installed push-button.
d. Sand or debris lodged in water flow control.
a. Open valve and allow water to fill tank.
b. Shut off water supply, disconnect supply line, and inspect all
gaskets and washers. Reassemble. See “Maintenance”
(step 13).
c. Readjust the push-button rod length as necessary. See step 12.
d. Shut off water supply. Remove the cap and clean as indicated
in step 13.
Slow or weak
flush
a. Bowl water level too low.
b. Supply valve partly closed.
c. Partially clogged trapway.
d. Supply pressure too low.
a. Check that the refill tube is connected to the water fill control
regulator and inserted into the refill float without being kinked
or damaged.
b. Open the supply valve completely. Be sure that the proper
supply tube is used.
c. Remove any obstruction. Consult a plumber if necessary.
d. Normal supply pressure must be at least 20 psi
Toilet leaks
a. Poor supply line connection.
b. Poor bowl to tank/floor connection.
a. Review step 9 of the installation procedure.
b. Reviews steps 4 to 7 of the installation procedure.
Toilet does not
shut off
a. Push-button rod is too long.
b. Flush valve seat and/or seal worn or deformed.
c. Sand or debris lodged in water flow control.
a. Readjust the rod as needed. See step 12.
b. Replace seal/flush valve assembly as needed.
c. Shut off water supply. Remove cap and clean as indicated
in step 13.
TANGO-3
Fabriqué et emballé en Chine /
Made and Packaged in China
Importé par / Imported by NOVELCA
Québec, Canada G2J 1C8
3021087
3021088
3021089
TASSILI.CA
SOULEVER
LE BRAS
D’ABORD